CONTROL ARM – Remove & Replace – 1500,4WD Lower,BOTH SIDES – [DOES NOT include alignment.]
CONTROL ARM – Remove & Replace – 4WD Upper,BOTH SIDES – [DOES NOT include alignment.]
PITMAN ARM – Remove & Replace – 1500,4WD – [Includes: R&I Steering Gear Assembly.] – [DOES NOT include alignment.]
IDLER ARM – Remove & Replace – 1500,4WD w/Skid Plate – [DOES NOT include alignment.]
ALIGNMENT
Check brake fluid for moisture and contamination. Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
STABILIZER BAR – Remove & Replace – 4WD
SHIPPING
KAARE T. gave our service a 5 star review on 12/20/2023
FLUSH COOLANT SYSTEM WITH BG ADDITIVE * Install radiator flushing chemical * Test drive before vehicle is pulled onto lift * Install coolant flushing machine to the vehicle's cooling system
TRANSMISSION OIL PAN GASKET &/OR FILTER – Remove & Replace – w/Skid Plate – [Includes: Confirm Fluid temperature for level check.]
P0010 INTAKE CAM ACT SOLENOID CONTROL CIRCUIT B1 TESTED INTAKE VVT SOLENOID, VVT SOLENOID DEFECTIVE, ALSO RECOMMEND REPLACING EXHAUST VVT SOLENOID AT THE SAME TIME CHECKED IGNITION TUNE UP PARTS, PUGS WORN AND DUE TO BE CHANGED. RECOMMEND PLUGS AND AIR INDUCTION SERVICE
LINDA D. gave our service a 5 star review on 1/6/2023
TRANSFER CASE VENT HOSE – INSPECT – [Check vent hoses for cracks, chafing, leaks, kinks and proper installation.] TRANSFER CASE FLUID – INSPECT CONDENSER – CLEAN PRESSURE CAP – CLEAN RADIATOR – CLEAN ENGINE ACCESSORY DRIVE BELT – INSPECT – [Replace if necessary.] ENGINE COOLING SYSTEM HOSES & CLAMPS – INSPECT EVAPORATIVE EMISSION SYSTEM – INSPECT – [Inspect all fuel and vapor lines and hoses for proper hook-up, routing, and condition. Check that the purge valve works properly, if equipped. Replace as needed.] EXHAUST SYSTEM – INSPECT FUEL SYSTEM – INSPECT COOLING SYSTEM – PRESSURE TEST PRESSURE CAP – PRESSURE TEST AIR CLEANER/ELEMENT – INSPECT – w/o Filter Restriction Indicator COOLANT – INSPECT – [Drain, flush, and refill every 150000 miles (240000 Km) or every 60 months, whichever occurs first.] TIRES – INSPECT – [Tires should be rotated every 5000 to 8000 miles, and/or at maintenance I or II service intervals. Check tire pressure, thread depth and wear.] —- SERPENTINE BELT AND A/C BELT CRACKED, RECOMMEND REPLACING POWER STEERING FLUID DIRTY, RECOMMEND FLUSH AIR FILTER OK BUT AIR FILTER BOX COVER BROKEN, RECOMMEND REPLACING FRONT BRAKES 80%, REAR BRAKES 70% SHOCKS AND STRUTS OK FRONT SWAY BAR
RIGHT REAR WINDOW SWITCH NEEDS REPLACED, MASTER SWITCH OK
A/C COMPRESSOR DRIVE BELT – Remove & Replace – [Includes: Serpentine and V-Belt type Belt(s).]
STABILIZER BAR CONTROL LINK – Remove & Replace – At Control Arm,Link Kit,Both
Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Install new power steering fluid. Install power steering additive to revitalize seals and . Road test vehicle.